![]() ![]() A full list is available on the specifications tab. The programmer will work with a wide variety of Atmel AVR microcontrollers including the Atmega8a and Atmega168a. On Linux And Mac OS X no kernel driver is required, just use AVRdude and specify the correct port. The driver will work on both 32 and 64 bit platforms. The latest Window Drivers are fully signed, so you can use them on Windows Vista and above without any issues. 10 pin ISP interface (conforms to standard ISP 10-pin pinout).Software controlled SCK option to support targets with low clock speed (Support for Windows, Mac OS X and Linux (will work on Windows 8.1).Allows you to read or write the microcontroller EEPROM, firmware, fuse bits and lock bits.Much easier to buy one fully built and programmed. ![]() In order to load the USBASP firmware onto the atmega8 on the programmer, yes you guessed it, you need an AVR programmer. The USB interface is achieved by using an atmega8 processor and the rest is done in firmware.īeing an Open source hardware (OSHW) project, released under the GNU General Public License, you are free to download the schematic and firmware from Thomas's website, but then you have a chicken and egg problem. Not only are they quite compact (70x20mm), but the design is really elegant. These AVR programmers are based on Thomas Fischl's USBasp design and connect to your computer's USB port. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |